Skip to content
solomotion
MakePhysics and particles

Drop it, let it fall

Any layer can fall, collide and tumble, in a flat comp and in a 3D world. You can add wind, throw sparks and confetti, and hang a sign on a rope.

Scrub, loop or export and every frame reads the same result. Nothing is baked.

Make a layer fall

  1. Select the layer and open the Physics tab in the inspector.
  2. In Body, choose Falls. The layer now collides and tumbles.
  3. Select the shelf or ground layer and choose Fixed. Other bodies land on it.
  4. Open Simulation and turn on Floor, or Walls to keep everything in frame.
  5. Set Starts to when physics takes over.

A body collides on what it is. A rectangle is a box, a circle is a circle, and a star, a path or a word uses its real outline. Change Shape to Box, Ball, Hull, Exact or Edge.

Choose Keys to let a layer move by its own keyframes and push whatever is in its way. A group is one body. Give each letter its own body to scatter a word.

Tune Bounce, Friction, Mass and Air. A little Follow pulls a falling layer back toward its keys for a wobble.

Blow things around

  1. Add a force to any layer with Add force in the Forces section.
  2. Pick a kind: wind, attract, vortex, turbulence or drag.
  3. Rotate the layer to aim it. Wind blows along the layer's +X, a vortex swirls around it, and attract pulls toward it.
  4. Set Radius to limit its reach.
  5. Keyframe the strength for a gust.

Forces stack. Order does not change the result.

Throw sparks and confetti

  1. On a layer, choose Add particles in the Particles section.
  2. Pick a kind: stream (flows while the layer is on), burst (pops at the start of its clip) or hit (throws off every contact).
  3. Move the clip so the burst lands on the beat.

Particles fall with gravity, feel every force and bounce off bodies. They never push a body back, and they work in flat comps only.

Hold it with a joint

  1. Select the body and choose Add a joint in Joints.
  2. Pick Pin (swings, like a hanging sign), Weld (one piece), Rope (slack until taut) or Spring (pulls back and bounces).
  3. Set the anchor, and a target body. Leave the target empty to hold the layer to the comp.

Slow it down

  1. In Simulation, set Speed below 1 for slow motion.
  2. Set Gravity. The default is 981, which is Earth. Set 0 to float.
  3. Leave Guard on so fast small bodies cannot skip through a wall.

Ask an agent

Agents use physics_scene, physics_body, physics_force, physics_emit, physics_joint and physics_inspect. Use physics_inspect to check where bodies are at a given moment.

Text
Drop the logo onto a shelf with a small bounce, then add a gust of wind that blows the confetti off the right edge.